Text Recognition

[waltham845]

I was using text recognition on some tifs I had imported. The tifs are bitonal and are also 600 pixels per inch.Some of the text is recognized and it comes up in the verify text dialog box. I can manipulate the text in the dialog box to where I want it, but once finished the OK button is greyed out.I have looked in the raster design options, and couldn't find anything pertaining to text recognition. So the text that I want can't be inserted. So is there a step I might be missing here?

[Glenn Pope]

*Note* Moved this thread from the Map forum to this one, as this is a Raster Design command.

[mjfarrell]

You would be best to simply say OK to
any text that Raster Design does recognize,
and then edit it later in MTEXT or through
spell checking it. That has been my experience.