Results 1 to 3 of 3

Thread: Error when opening file

  1. #1
    Member pogibob's Avatar
    Join Date
    2006-04
    Location
    Huntington Beach, CA
    Posts
    14
    Login to Give a bone
    0

    Default Error when opening file

    I'm sure others have come across this before. When i try to open a file i get this error: "An attempt was made to access Site Massing - Central.rvt past its end." Any idea what this means and am is this file lost? Its the first time i have seen it. I cant think of what i could have done to the file to have this happen. Any comments, helps, thoughts are appreciated.

    Thanks.

  2. #2
    I could stop if I wanted to
    Join Date
    2003-03
    Location
    Reno, Nv.
    Posts
    277
    Login to Give a bone
    0

    Default Re: Error when opening file

    There was a thread a while back about "Past it's End" error messages. Didn't seem like anybody knew what the problem was. Some people had this message on a large file, some small. Some had it happen on a workshared file, others not.

    General consensus was, contact Revit support.

  3. #3
    Member pogibob's Avatar
    Join Date
    2006-04
    Location
    Huntington Beach, CA
    Posts
    14
    Login to Give a bone
    0

    Default Re: Error when opening file

    Sounds good, I will do that. Thank you for replying!

Similar Threads

  1. Error when opening a file with SP 03
    By S.Agnew in forum Inventor View - General
    Replies: 0
    Last Post: 2010-05-04, 02:47 PM
  2. Error when opening a .dxf file...
    By terynl in forum ACA General
    Replies: 1
    Last Post: 2009-08-04, 12:55 PM
  3. Error While opening DWF file
    By satish in forum Design Review - General
    Replies: 1
    Last Post: 2009-03-02, 12:38 PM
  4. Replies: 3
    Last Post: 2008-07-28, 07:31 AM
  5. Error When Opening a file???
    By KELLI in forum Revit Architecture - General
    Replies: 9
    Last Post: 2007-10-04, 02:42 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •