ADT 3.3 Problems / frustrations

[DeluXe]

Ok... so two weeks ago my work computer crashed, and i lost all my programs. All my important work files were saved on the network.. and i just got my computer fixed and back in the office today. During the week i didnt have a computer i was using autocad 2006 on my laptop - saving all files to 2000 format.

Today i reinstalled autocad 3.3 due to company request, although i would prefer 2006 any day.... and im back to seeing those ARX errors every time i open a drawing.
i am unable to refedit anything (titleblocks - simple light blocks etc.) and when copy-pasting from dwg to dwg im getting the

'ARX ERROR: eduplicatekey'

error that i have to hit enter through 4-8 times then the msg talking about not allowing the newer AEC objects to participate comes up. I am able to paste in the objects after this, but its really annoying.. is there anything i can do about that?

i know i can use a setting to turn off alert boxes, but id rather not. I also have installed service pack two - for ADT 3.3

any suggestions are appreciated.
thanks.

[H-Angus]

For newer releases, 2004-2006 there is a hotfix for object enablers to stop this from happening, as 3.3(2002) is no longer supported by Autodesk I'm not sure if they released an object enabler for it.

[H-Angus]

Well looking at the Autodesk website unfortunately it doesn't look like there is one available.

[DeluXe]

thanks for the research on the autodesk site. :S