Results 1 to 2 of 2

Thread: sat

  1. 2004-07-26, 01:07 PM #1
    rkilbreath
    rkilbreath is offline
    Woo! Hoo! my 1st post
    Join Date
    2004-07
    Posts
    1
    Login to Give a bone
    0

    Default sat

    have trouble with exporting solids form CAD to AutoDesk Inventor. the solid
    when exported into inventor is configured to large
    Reply With Quote Reply With Quote
  2. 2004-07-28, 05:42 AM #2
    chadwickt
    chadwickt is offline
    Active Member chadwickt's Avatar
    Join Date
    2015-12
    Posts
    84
    Login to Give a bone
    0

    Default Re: sat

    Quote Originally Posted by rkilbreath
    have trouble with exporting solids form CAD to AutoDesk Inventor. the solid
    when exported into inventor is configured to large
    As you are stepping through the wizard, at one point in the upper left it asks for the units the part was created in. Do you have this set to the correct units?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules