Block references itself

[jeff.garr]

I am trying to insert a block I created into ACAD 2004 and keep getting the error: "Block A-SYMB-RMNR references itself *Invalid*". Any thoughts as to what I may have done? I created the attributes for the block with the "Att" command and it also includes a rectangle constructed of one polyline. The block itself is to specify room numbers on a building layout. I did include an attachment of the block I created if anyone wants to view. Any help would be appreciated.....

[richard.binning]

I am trying to insert a block I created into ACAD 2004 and keep getting the error: "Block A-SYMB-RMNR references itself *Invalid*". Any thoughts as to what I may have done? I created the attributes for the block with the "Att" command and it also includes a rectangle constructed of one polyline. The block itself is to specify room numbers on a building layout. I did include an attachment of the block I created if anyone wants to view. Any help would be appreciated.....

Open the original drawing and explode the block, then run a purge. Now you'll be able to insert it into other drawings.

RLB

[jeff.garr]

Thank you for the help! Also, sorry for posting this in the wrong area- it has been a while since I have last used your help. Thanks Again!!

Regards,
Jeffrey Garr