Fraction Too Close

[cosmojr]

Is there a way to get a little space between the fraction and whole number of a dimension? I am using AutoCAD 2004 and the fraction is stacked horz but it is close either in horizontal or diagonal. Also I am trying this in fractional type unit format. I guess I should see if it makes a diff if I try arch but one would hope I could do it on either.

[mjfarrell]

ANy help in here:

http://usa.autodesk.com/adsk/servlet...linkID=2475323

http://usa.autodesk.com/adsk/servlet...linkID=2475874

http://usa.autodesk.com/adsk/servlet...linkID=2475323

[scott.wilcox]

Make sure the Remove Leading Blank box is unchecked in Autostack properties (see attached image).

You can access it by highlighting the fraction in the MTEXT box, right-clicking, select properties, select Autostack..

Scott

[cosmojr]

No, these are more for fraction font size or height. I am looking for the space between the whole number and the fraction ex: 11/2 should be 1 1/2 but only. It looks better in arch style but in fraction unit style it just looks too close. My guess is I am stuck with it this way.

[cosmojr]

How do I get to it from within a dimension. This is what I see when I try to edit the dimension.

[Mike.Perry]

Hi

Check out the following Submission # EX001027 by Peter Jamtgaard on the AUGI Exchange Page -

AUGI Exchange Search Page

Using this routine will allow you to add the necessary space(s) that you require.

Have a good one, Mike

[cosmojr]

EX001027 works but I would have to add a space and that is to much. I guess this is a function of the font and I will play with fonts to find one that looks better. I am currently using ROMANS.
Thanks for the tries.