Audit purge loop

[kathy71046]

If I audit then purge, when I audit again I get

"106 Blocks audited

Total errors found 441 fixed 441"

then if I delete the $AUDIT-BAD-LAYER, it will again find the same errors, and same thing with purging 17 *Dxxx blocks.

What is the best option for minimising crashiness with these very old, overused drawings until I can filter through to nice clean new drawings?

(I've crashed fatally about 6 times today)

[lpseifert]

Have you tried to Wblock the entities for a fresh dwg? Sometimes it cures a multitude of ills.

[kathy71046]

As I said, very old drawings.

I didn't think Wblocking an entire drawing would be very practical, but was surprisingly painless.

Thanks for the suggestion lpseifert.

[cperez.73833]

THANK YOU!! You have just made my day - Wblock deleted all the trash that was creating fatal errors.