Results 1 to 4 of 4

Thread: keep getting a "class not registered" error

  1. #1
    Member
    Join Date
    2007-08
    Location
    Pacific Nw
    Posts
    9
    Login to Give a bone
    0

    Question keep getting a "class not registered" error

    when I open the tool palette and attempt to use any item within it gives this message. What wrong, and whats the fix

  2. #2
    Wish List Manager BrenBren's Avatar
    Join Date
    2000-11
    Location
    150700
    Posts
    3,439
    Login to Give a bone
    0

    Default Re: keep getting a "class not registered" error

    Quote Originally Posted by architectural-designer
    when I open the tool palette and attempt to use any item within it gives this message. What wrong, and whats the fix
    This question has been asked a few times. This is one thread where I believe an answer is posted. If you still can't find it, check the similar threads tool at the bottom of this thread, or the search tool, searching for CLASS + REGISTERED

  3. #3
    AUGI Addict
    Join Date
    2005-07
    Posts
    2,356
    Login to Give a bone
    0

    Default Re: keep getting a "class not registered" error

    Quote Originally Posted by architectural-designer
    when I open the tool palette and attempt to use any item within it gives this message. What wrong, and whats the fix
    Try doing a repair installation, that should fix it.

  4. #4
    Active Member
    Join Date
    2007-02
    Location
    Tucson, AZ
    Posts
    60
    Login to Give a bone
    0

    Default Re: keep getting a "class not registered" error

    I was getting this, too. I installed the recent patch from AutoDesk and it fixed it - or at least I'm no longer getting the error.

Similar Threads

  1. "Unable to execute the tool. Class not registered."
    By tntdraftsol in forum ACA General
    Replies: 2
    Last Post: 2009-02-25, 05:56 PM
  2. "Class description isn't identical with registered class"
    By sinc in forum AutoCAD Map 3D - General
    Replies: 0
    Last Post: 2007-01-22, 06:39 AM
  3. Replies: 1
    Last Post: 2006-11-08, 03:38 AM
  4. Replies: 1
    Last Post: 2005-11-15, 07:35 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •