YES / NO visibitly Paramaters Bad Buggy Behaviour?

[Martin P]

Anyone else come across this? I have now got 2 separate familes that adjusting a Yes / No Paramater for a visibility setting makes the families leap in and out of the walls - only when they are set to certain sizes?? ( awindow familiy and door family)

However if I make the family 0.1mm different in size they work fine. or if I put the Yes / no to yes they work fine?

These families work fine when flexing in the familiy and also at almost all sizes in the model - occasionaly there is a size that makes it behave very oddly unless I take 0.1mm off the width or I switch back on the yes / no paramter???

Very weird behaviour.......

Here are some examples - this is surely a bug and not something I am doing wrong??

I have no idea why, but this file seemd to get bigger as I purged!?

Any advice appreciated.

Thanks.

[SkiSouth]

only had time to work on the window. It appears the cill was not locked to the reference planes of the sides of the window.

[Martin P]

Crickey! Was it really that? Thank you very much for looking over that for me, I couldnt understand why it only happened at specific sizes....... such a simple mistake, I just couldnt see the wood for the trees!

Thanks again, good to know it is me and not a bug anyway!!

[SkiSouth]

no problem. I'll have a go at the door too later, just a full week still ahead.