Hi All,
I have been working in a Revit Structure Model where I suppose to replace a 28LH girder with a 36G4N joist girder on a 48'-9" span. Apparenty, it cannot be done because I get an error message that says it cannot create this type of girder. I want to mention that 36G4N8K type does not exist in the library. After few attempts to create one we failed. OK, I have tried to trick the model and to use a 36LH size but I get the same error, probably because the depth is to high for this span. My engineers told me that a 36LH cannot span on a 48'-9" but a 36G4N8K should work just fine. So, I reached a stopping point and I desperately need help. Any suggestions would be greatly appreciated.
Thanks a lot.
Sincerely,
Dan Ungureanu