Inventor Pipe routing and CADWorx

[masoodkamal]

Hi

I have to work on piping design for power plants. i want to know how good is the piping functionality of inventor is. to make myself clear how can i compare CADworx with inventor.

[Hugh_Compton]

Inventor Professional (you will need the Pro version for the pipework module) is capable of AUTOMATICALLY routing your pipework (ie click a start point and an end point and bang, there is your pipe run). It also allows you to click the resulting route and offer another suggested route if it doesn't suit you.

I think to answer your question properly you'd have to write an essay - basically though CADWorx is a cabbage and Inventor Pro is a sports car.
---------------------------------------
Pipework & Structural Steel http://www.3DCADMax.com

[danadams01]

Hi

I have to work on piping design for power plants. i want to know how good is the piping functionality of inventor is. to make myself clear how can i compare CADworx with inventor.

I need to chip away at channeling plan for power plants. I need to realize how great is the channeling usefulness of designer is. to make myself clear how might I contrast CADworx and creator.

[danadams01]

Hi

I have to work on piping design for power plants. i want to know how good is the piping functionality of inventor is. to make myself clear how can i compare CADworx with inventor.

Very good.

I did not have broser enabled for some reason when I downloaded Inventor.

I followed your instruction and bingo: broswer shows now.

Thank you for the tip