I can not get the balusters in a railing to show in plan when I drop the cut plane. They are visible in vertical sections, 3D views, and elevations but not detail plans or plans.
Kevin
|
|
|
I can not get the balusters in a railing to show in plan when I drop the cut plane. They are visible in vertical sections, 3D views, and elevations but not detail plans or plans.
Kevin
open the baluster family, draw around baluster shape using symbolic lines, load baluster into project.
This works for me.
Roy
Edit. Warning. Does not work with plan regions unless the entire railing is enclosed in the plan region. If any part of the rails above the balusters are outside the boundary the entire rail is shown thus hiding the symbolic lines. I'll work on it!
Last edited by roy.70844; 2008-02-05 at 10:44 AM.
Thanks for the information! Since they are profiles, I forgot about symbolic lines. The rails work fine in section so I assumed the balusters would also.
What was I thinking that they both would act the same!!!!
Kevin