I created a wall with a log siding profile sweep. A crossection thru the building has the first floor wall, then the second floor system, then the second floor wall and then the roof. My problem is the siding sweep stops at the second floor. I can add a floor edge sweep but the coursing does not match with that of the walls above and below. I tried using plain walls without sweeps and using a veneer wall with the sweeps over it so I could run it from the first floor to the roof, but my windows will not cut both the wall and the veneer wall. I tried extending the first floor wall with sweeps clear to the roof through the floor at my dormer wall but then the second floor dormer walls will not join properly with the two story wall. I can't unlock the sweeps in the wall editing section

Any ideas?