I am starting a new project and have been going through the process of setting up my site model. Its a reasonable size site about 200m long and 100m deep.

I am working on the Structural drawings (don't hold that against me) and am linking in architectural and survey drawings in DWG format.

I just cant seem to get the shared co-ordinates working

This is what I am doing so far;

-setup of site file with site DWG file linked centre-to-centre
-Acquire Co-Ordinates of site file
-Save etc

I am basically working to Wes's tip here http://forums.augi.com/showthread.ph...797#post718797

Then when I link in the next drawing with shared co-ordinates checked to the same World Co-Ordinates system it doesn't bring in the drawing correctly.

And it also isn't exporting the linked drawing to the acquired Coordinates

Am I missing something here, is there something else I am forgetting to do?