iAssembly DOF

[vittal.muthyala]

I have created an iAssembly (Inventor 2008 User). When I check for DOF (Degrees Of Freedom) I found that, all the DOF are constrained or restricted or fixed, which is correct. But, when I add a hole feature in assembly and check for DOF, its displaying me the DOF symbology (Movement and Rotiation). Even I tried by converting to Weldment and added the Hole Feature in Machining preparations. But, still the result shows the DOF symbol.

Please help me how can I proceed further and resolve it.

[tao.liu]

where did you add the hole feature?
If you add the hole feature in an part, it seems to be no problem

if you add the hole feature in the iAssembly, I am afraind you have to open each
sub-assemble model, and then make constraints again