Summary: I wish the Edit Baluster Placement dialog had an additional justify option of "shrink to fit"

Description: I wish the Edit Baluster Placement dialog had an additional justify option of "shrink to fit".

In this case, Revit would change the current setting to NOT allow spacing beyond what is set: perhaps make it a checkbox option within the settings.

How Used: Often building codes contain a maximum spacing for balusters, the current justification option of "spread to fit" will sometimes provide a solution with spacing greater than the specified spacing. The ability to specify a solution that does not exceed the specified spacing would be useful in those cases.

Feature Affinity: Stairs, Ramps, and Railings

Submitted By: Brett Wagner on April 1, 2008