Results 1 to 4 of 4

Thread: Turn of wall visibility on upper floors...

  1. #1
    Active Member
    Join Date
    2007-11
    Posts
    50
    Login to Give a bone
    0

    Default Turn of wall visibility on upper floors...

    Does anyone know how to turn off visibility of walls from lower floors? (I am seeing the walls drawn on the floor below and I have to go through and hide each one - there must be an easier way)

  2. #2
    AUGI Addict DaveP's Avatar
    Join Date
    2002-12
    Location
    St Paul, MN
    Posts
    1,569
    Login to Give a bone
    0

    Default Re: Turn of wall visibility on upper floors...

    Have you put a Floor in yet?
    the Walls below will show through if there is no Floor to hide them.
    The other thing to look at is to make sure that the Walls below do not extend above your current Level

  3. #3
    AUGI Addict
    Join Date
    2001-12
    Posts
    1,714
    Login to Give a bone
    0

    Default Re: Turn of wall visibility on upper floors...

    Quote Originally Posted by DaveP View Post
    Have you put a Floor in yet?
    the Walls below will show through if there is no Floor to hide them.
    The other thing to look at is to make sure that the Walls below do not extend above your current Level
    Also, check to make sure View Range is set to Associated Level. If it is set to a level below or Unlimited this can happen. If there is an area where you need to tweak View Range, do it with a Plan Region, rather than for the whole view, and you will save some time.

    best,
    Gordon

  4. #4
    I could stop if I wanted to
    Join Date
    2003-10
    Location
    Santa Barbara
    Posts
    397
    Login to Give a bone
    0

    Default Re: Turn of wall visibility on upper floors...

    make sure you dont have an "Underlay" turned on

Similar Threads

  1. 2013: Floors turn transparent
    By gkleyn358017 in forum Revit Architecture - General
    Replies: 0
    Last Post: 2013-02-14, 04:54 AM
  2. 2012: Any way to make a wall-hosted family with base AND upper level constraints?
    By patricks in forum Revit Architecture - Families
    Replies: 5
    Last Post: 2012-04-11, 05:56 PM
  3. Turn Voids visibility On/Off.
    By Wish List System in forum Revit MEP - Wish List
    Replies: 0
    Last Post: 2011-10-18, 06:27 PM
  4. Best practice - upper cabinets (wall hosted)
    By tonyisenhoff in forum Revit Architecture - General
    Replies: 1
    Last Post: 2006-03-21, 09:11 PM
  5. Finish floors you can turn off
    By archjake in forum Revit Architecture - Tips & Tricks
    Replies: 3
    Last Post: 2004-07-19, 01:01 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •