My PC3s Publish to a Single PDF, PLT File

[ghyde.164847]

Can anyone answer why my newly setup PC3 files seem to only publish into single files.

We have AutoCAD 2008, Cute PDF, Acrobat 8 Pro and generate PLTs using an HP750c HDI driver. Even if I set up a stop to prompt for a filename, it asks for a file name then proceeds to put all drawings selected into the single PDF or PLT file.

This is very frustrating now and I have exhausted all options.

Advice/assistnace would be gratefully received.

Thanks in advance.

[H-Angus]

Can anyone answer why my newly setup PC3 files seem to only publish into single files.

We have AutoCAD 2008, Cute PDF, Acrobat 8 Pro and generate PLTs using an HP750c HDI driver. Even if I set up a stop to prompt for a filename, it asks for a file name then proceeds to put all drawings selected into the single PDF or PLT file.

This is very frustrating now and I have exhausted all options.

Advice/assistnace would be gratefully received.

Thanks in advance.

What is your PUBLISHCOLLATE system variable set to? It should be set to 1 to publish multi-sheet pdf's.

[ghyde.164847]

Thank you very much, sir!

That works a treat.