can't fillet or trim lines (which are in same z-plane); getting comment: 'lines non-coplaner'.
what's going on?
|
can't fillet or trim lines (which are in same z-plane); getting comment: 'lines non-coplaner'.
what's going on?
getting message 'lines non-coplaner' when filleting or trimming lines in same z-plane (acadd 2007)
check the UCS. sometimes that has messed up my z-values before - not sure why, though.
sounds like one of your lines are at a different height than the other (Z + or -)
I thought the OP mentioned in his first posts that the lines are on the same Z plane.........so would flatten do anything for that instance?