Problem With Wall Intersection Cleanups

[CADdancer]

Hello AUGI Members,

I am experiencing a strange problem when placing walls on my drawings. Initially all of the walls appear to be placed correctly with all of the corners and intersections cleaned up properly. However, once I save and close the drawing and then open it up at a later time some of the wall corners and intersections are not cleaned up and display as separate wall segments one on top of the other.

I have checked everything I know to eliminate this anomaly from happening but it continues to happen on many (not all) drawings. Has anyone experienced this type of problem....??....if so can you suggest or recommend a solution to resolve and eliminate this from happening again....??

Any assistance will be appreciated.....!

Regards,
Vince

[H-Angus]

Hello AUGI Members,

I am experiencing a strange problem when placing walls on my drawings. Initially all of the walls appear to be placed correctly with all of the corners and intersections cleaned up properly. However, once I save and close the drawing and then open it up at a later time some of the wall corners and intersections are not cleaned up and display as separate wall segments one on top of the other.

I have checked everything I know to eliminate this anomaly from happening but it continues to happen on many (not all) drawings. Has anyone experienced this type of problem....??....if so can you suggest or recommend a solution to resolve and eliminate this from happening again....??

Any assistance will be appreciated.....!


Regards,
Vince

It could be a whole host of reasons from clean up radius settings, clean up groups, wall component priorities, the elevation of individual walls or the presence of wall sweeps or body modifiers.

Are you able to post an example file containing the offending walls to take a look at?

Also what version of ACA are you using?