HI. I'AM TRYING TO PLOT FROM THE LAYOUT MODE AND GET KICKED OUT OF THE PROGRAM. I CAN GO TO MODEL SPACE AND IT WORKS FINE.
WERE USING CIVIL 3D 2008.
ANY SUGESTIONS WOULD BE GERAT.
THANKS FOR THE HELP
|
HI. I'AM TRYING TO PLOT FROM THE LAYOUT MODE AND GET KICKED OUT OF THE PROGRAM. I CAN GO TO MODEL SPACE AND IT WORKS FINE.
WERE USING CIVIL 3D 2008.
ANY SUGESTIONS WOULD BE GERAT.
THANKS FOR THE HELP
Any and every drawing file, or only a certain one?
R.K. McSwain | CAD Panacea |
It happens in all dwg's including LDT, althrough I can publish the dwg sometimes.
Last edited by KAMINSKYPHIL; 2008-07-31 at 01:35 PM.
You might need to run the Repair function on Civil. I have had to do that after a bad file corrupted my computer and it caused Civil to act funny. It works well and takes less than a hour so less down time. Worth a try when you have time to work on the issue.
I FOUND THE PROBLEM, IT WAS THE PAGE SETUP, SOMEONE IN OUR OFFICE CORRUPTED THE PC3 FILE I HAD ATTACHED, WHEN I REPLACED THE PC3 FILE EVERYTHING WORKED FINE..
THANKS FOR THE INPUT TO TRY TO SOLVE.
We've stopped using PC3 files in our office because of problems with them. We found that plots would just disappear from the queue and not plot out. We're using a mixture of autocad/c3d versions which could be causing the problems.
R.K. McSwain | CAD Panacea |
What kind of problems?
How do you get consistent plot output without everyone using the same PC3 files?
Does everyone just print to their system printer and make changes as needed, and create temporary PC3 files?
R.K. McSwain | CAD Panacea |
Hi,
Plotting with PC3 files sometimes resulted in plots dissapearing into cyberspace. Not using PC3s always works. I haven't known where to start to try to fix it, especially across multiple releases and a mix of LT and Civil3D.
Not saying they're not useful...we just don't use them.
We only rarely make changes to printer settings. It's all controlled through the .ctb file.