Plotting output is offset in 2008

[mmack]

I'm plotting a 36x24 drawing in AutoCAD 2008. I'm using the Autodesk default DWG to PDF plotter. When I view the plot in preview it looks perfect. When I plot and check the pdf the whole drawing is offset by a few inches. It cuts off part of the drawing. Anyone ever see this before. I tried creating my own paper size, change the margins. Any help would be much appreciated

[parweld]

That happened to me in 2007. I ended up unchecking the box for centering the plot, and played around with different numbers to make it work right. When I preveiwed the plot in AutoCad, it was running off the paper, but in Adobe it was centered. Hope this helps you.

[irneb]

I've found this happens sometimes with PDF drivers other than AutoCAD's DWG to PDF printer. Solution was to re-install the PDF Writer (Adobe or other). Then for some reason I can't figure out, it just changes to something different of its own accord - even the page size goes hay-wire.

Otherwise 1st make a DWF then print to PDF.