How can I assemble a wall?

[nsinha73]

I have placed all my Finishes on my Wall, But I'd also like to place a Plate at 10'-0". Have you guys ever done this?....If so, then how can I achieve this?
Thanks

[Andre Carvalho]

You could run a profile embedded into the wall assembly... But I wouldn't do that. I would add the plate as a detail component in section.

Andre Carvalho

[nsinha73]

Ok that should work....I had figured that out, but I could see problems may arise due to that.
Thanks!

[sfaust]

you could also add it as a sweep independent of the wall construction...