I have two spaces on a particular floor that won't let me adjust the upper limit to the next floor (ie I want to go from Level 0 to Level 1). The warning "Could not create geometry for Space" shows up and my space can't be created. The warning occurs when I set the Upper Limit to Level 0 and adjust my Limit Offset to the slab above and also when I set the Upper Limit to Level 1 with the Limit Offset at 0' 0". I am able to create and maintain a space only when it is below a certain height. All other spaces on the floor are set for Upper Limit = Level 1 with no offsets and they work as intended. I am thinking it has something to do with the architectural model in that location, but am not sure. Has anyone else run into this problem?