I'm having trouble getting my 18k4 bar joists to show correctly on my drawing.
I created a beam system to show my bar joist @ 5'-0" o.c. they look fine in plan, but when I cut a section, the ends of my bar joists are shown extending 6" into the precast panel.
Beacuse the precast panel extends up to form a parapet, I was wanting my bar joists to stop at the face of the precast, and sit on bearing angle.
Is there a way to get my joist to stop at the face of the precast? And how can I show a bearing angle with an anchor into the precast panel?
Any help is greatly appreciated.