railing

[singhishpal2]

How to do this type of railing.
I am waiting for your answers

[iankids]

Hi singhishpal2,

Within the standard metric version of Revit (& I assume the imperial version) there is a railing provided called 900mm pipe. This can be adjusted to suit your needs.
If you are unable to locate it, it will be readily available through the online search panel towards the top of your revit screen.

Cheers,

Ian

[Andre Carvalho]

You will have to tweak a little your baluster to make it not to be perpendicular to the tread. If you do a search in the forum you will find a discussion about how to do it.

Andre Carvalho

[Mike Sealander]

That inside rail is going to be difficult. You might want to consider modelling that as an in-place family. The photo suggests there is only one baluster at the middle landing. I would be surprised if you can do this using the railing family.