im using civil3d 2009 and map 2009
i have a shape file with topo for my entire county.
i have geo-referenced aerial photographs.
i connect to the locations, bring in the photos i want the topo for.
then i bring in the topo with a query to limit it to the area i want.
i then export to a dwg
my problem is that all the contours come in at elevation 0.
there are also 5 labels in each location where i had labeled them in map
i would leave it in map, but its so slow compared to civil 3d due to the large amount of contours, even with a query.
any ideas? am i going about this the wrong way?