UCS parameters

[kane333]

I use ID Point alot while working in 3D. At one point, I had the settings correct where when I IDed a point, it would give me Architectural coordinates. I.E. 357' 9 3/4". Since I've started working on a fresh drawing, the numbers only read in inches which means I have to break out the calculator to figure out what 4359.5875" equals. Is there a system variable that I have to change to get it to read Architectural again or does it have something to do with the Customization File? Thank you in advance.

[jaberwok]

Look into the UNITS command.

[kane333]

That did the trick. I had played around in there for a little bit but I'm always scared of changing a setting and having things not work correctly on later drawings. Happens to me all the time. Thank you.