I am using the standard dashdot linetype, but lines are always missing the last dot - there is just a gap. I've checked the code and can't see why it would be missing. Any ideas?
|
I am using the standard dashdot linetype, but lines are always missing the last dot - there is just a gap. I've checked the code and can't see why it would be missing. Any ideas?
It does finish with a dash, but is missing the last dot. It looks like this:
_ . _ . _ _
Unfortunately this is because the line is just too short/long to have roomto add the last dot before finishing (always) with a dash. Copy it and try stretching it slightly and I think you'll find the dot appear.
You can cheat by adjusting the CELTScale or linetype scale in the properties for this line by a small amount to force the dot to appear.
Thanks for the suggestions, but they haven't fixed the problem. Changing the scale or length makes no difference. I'va attached a screenshot showing some sample lines.
That is weird. Sorry, I've not seen that before.
I wonder if your Lin files have been edited. Here is a copy of the vanilla Lin files. Load these up & see if the error still occurs.
Sorry to say, but still no difference. Maybe its just one of those things.
Here's a sample file with a few lines showing the problem. Hope this helps.
There must be something wrong with your ACad. Did you save Norton_cad's linetype definition files over your own?
You drawing appears fine when I open it on my PC.