Originally Posted by
mjfarrell
There is one good way to perform this task.
Set up as many point groups as are required.
Establish Point Label styles (this will place the correct symbols
in the drawing, and it will still be connected to the point database)
This should be your preferred method honestly.
Then apply the desired point label style to the point groups.
Your post would indicate a need for some training to increase your
understanding of Land Desktop, Points and Point Label styles.
THe earlier method posted would work, only it would require additional
steps to use than I posted. In review of that method it was too cumbersome
thus I am revising my suggestion to use ONLY point label style as the
desired method.