Crop Region shows on sheet in model, but not print preview

[Denis01]

When I select "Crop Region Visible" in the view properties (and select Crop View), the view shows the outline around the view on the model view but does not show in print preview. I'd like to have an outline around the details on the sheet, but can get them to show in print preview. It works fine on other sheets where I have the same "Crop View" and "Crop Region Visible") parameters checked "on" in View Properties of the activated view.

I'm sure that some of you know what's happening here, but I sure don't. I appreciate any suggestions.

Denis

[twiceroadsfool]

When you go to Print, click setup at the bottom right, to get in to the set up dialogue.

There are 5 or 6 check boxes at the bottom. One says "Hide Crop Regions." Make sure its UNchecked, otherwise none of them print...

[Denis01]

That was it (but you know that).

Thanks again. You're saving me hours of wasted time (and my liver).
Denis