Roof Rafter Cut weirdness

[rtaube]

I'm having an issue getting my rafter to cuts to work properly. The Plumb Cut seems to be fine, but I'd like to use a Two Cut Square, however the program is giving me a very bizarre result and I'm not sure how to fix it. Is there a roof profile that determines how the cuts are supposed to look and did mine get changed somehow?
Please look at the attached image, I'm using Revit 2010.
Also, the view I have show is a callout view of a section, but this is a modeling issue as it shows up in all views.

Thanks,
Ryan

[harrisbrett]

After you select Two Cut-Square, set the Fascia Depth parameter to something other than 0

[rtaube]

so simple, sorry for the newbie question
thank you very much