Good evening,
I have been trying to get my mouse man wheel to work with zoom and pan, I was able to get it to zoom, but as far as pan is concerned I can not, I have downloaded the latest drivers for the mouse, I have gone into Autodesk to check some of the comments regarding this feature, tried all of them without avail, at this point I don't know what else to do, go out and buy another mouse, perhaps, but this mouse works well, I have had for a while now, of course I was not doing much ACAD at the time, until now.
Any suggestions will be greatly appreciated.
Thanks for your support.
Sincerely
Mariae